Turn On MessageDSC programming
Setting the clockThis unit offers you the possibility to enter aThe car radio has been equipped with DSC
turn on message of up to 40 characters. The(Direct Software Control) to allow you to
Set the clock in the DSC mode.
message will briefly appear in the displaycustomize certain programmable, basic
l Press DSC briefly.each time you turn the unit on.settings to suit your personal needs and
lPress A I v to select the functionProceed as follows:preferences and then store them.
?CLOCKSEP.The basic settings for this car radio were
Select the DSC mode.
l Press -z-z >> to activate the hours or_Press DSC.made at the factory.
the minutes. The option you can set-In the following you can find an overview of
.Press A / v to select TOM.
will flash.these settings, so that you can always reset
.Press c< to turn the message off.
lPress A/V to alter the flashingto them if desired.
display..Press >> two times to select the editIf you wish to alter any of the programming,
mode.
lWhen you have completed the setting,l press DSC.
press DSC briefly to store it. .If there is no TOM programmed,MENU v / A will temporarily appear in the
lPress DSC again to exit DSC mode.dashes ?_I?will appear in the display.display.
.The cursor will flash at the current
Use the A I v buttons of the rocker switch
position. Press c< / >> to move theto select the function you wish to change.
cursor.
The display will show you the setting you
.Press A / v to select a character. If youhave selected. Press the << z=> buttons of
want to enter a blank, select the dashthe rocker switch to change the settings and
I, I,
_.exit the current mode. Confirm the setting
.Press DSC to store the message.you have selected by pressing the DSC
button.
Press DSC again to quit the DSC
mode.
If you want to change the message, select
LTOM in the DSC mode and overwrite it in
the edit mode. If you want to change just a
few of the letters, press cc I >> to move the
cursor to the corresponding position and
change that character only.A / V Select function
C-Z >> Adpst/recall setting
16 |